Protriptyline Hydrochloride Tablets
» Protriptyline Hydrochloride Tablets contain not less than 90.0 percent and not more than 110.0 percent of the labeled amount of C19H21N·HCl.
Packaging and storage
Preserve in tight containers.
Identification
A:
The retention time of the major peak in the chromatogram of the Assay preparation corresponds to that in the chromatogram of the Standard preparation, as obtained in the Assay.
B:
A filtered solution of finely powdered Tablets, equivalent to protriptyline hydrochloride solution (1 in 20), meets the requirements of the tests for Chloride
![]() ![]()
Dissolution
![]() ![]()
Medium:
water; 900 mL.
Apparatus 1:
100 rpm.
Time:
45 minutes.
Procedure
Determine the amount of C19H21N·HCl dissolved from UV absorbances at the wavelength of maximum absorbance at about 290 nm of filtered portions of the solution under test, suitably diluted with Dissolution Medium, if necessary, in comparison with a Standard solution having a known concentration of USP Protriptyline Hydrochloride RS in the same medium.
Tolerances
Not less than 75% (Q) of the labeled amount of C19H21N·HCl is dissolved in 45 minutes.
Uniformity of dosage units
![]() ![]()
procedure for content uniformity
Solution A, Solution B, Mobile phase, Diluent, Standard preparation, and Chromatographic system
Proceed as directed in the Assay.
Test preparation
Transfer 1 finely powdered Tablet to a 50-mL volumetric flask, add about 1 mL of 2.5 N hydrochloric acid and 5 mL of water for each 5 mg of protriptyline hydrochloride, and shake by mechanical means for 20 minutes or until the Tablet is fully disintegrated. Add 5 mL of alcohol for each 5 mg of protriptyline hydrochloride, and shake for an additional 10 minutes. Dilute with water to volume, mix, and pass through a 0.45-µm membrane filter, discarding the first 1.5 mL of the filtrate. Use the subsequent filtrate as the Test preparation.
Procedure
Proceed as directed in the Assay. Calculate the quantity, in mg, of protriptyline hydrochloride (C19H21N·HCl) in the Tablet taken by the formula:
(TC / D)(rU / rS)
in which T is the labeled quantity, in mg, of protriptyline hydrochloride in the Tablet; C is the concentration, in µg per mL, of USP Protriptyline Hydrochloride RS in the Standard preparation; D is the concentration, in µg per mL, of protriptyline hydrochloride in the Test preparation, based on the labeled quantity per Tablet and the extent of dilution; and rU and rS are the peak responses obtained from the Test preparation and the Standard preparation, respectively.
Assay
Solution A
Prepare a filtered and degassed solution of 22.0 g of monobasic sodium phosphate and 3.78 g of sodium 1-hexanesulfonate in 1900 mL of water. Adjust with phosphoric acid to a pH of 2.90, and dilute with water to volume in a 2000-mL volumetric flask. Make adjustments if necessary (see System Suitability under Chromatography
![]() ![]()
Solution B
Use filtered and degassed acetonitrile. Make adjustments if necessary (see System Suitability under Chromatography
![]() ![]()
Mobile phase
Use variable mixtures of Solution A and Solution B as directed for Chromatographic system.
Diluent
Add 200 mL of alcohol to a 1000-mL volumetric flask. Add 40 mL of 2.5 N hydrochloric acid, dilute with water to volume, and mix.
Standard preparation
Dissolve an accurately weighed quantity of USP Protriptyline Hydrochloride RS in Diluent, and dilute quantitatively, and stepwise if necessary, with Diluent to obtain a solution having a known concentration of about 0.20 mg per mL.
Assay preparation
Weigh and finely powder not fewer than 20 Tablets. Transfer an accurately weighed portion of the powder, equivalent to about 40 mg of protriptyline hydrochloride, to a 200-mL volumetric flask, add 40 mL of alcohol, and shake by mechanical means for 5 minutes. Add 40 mL of water and 8 mL of 2.5 N hydrochloric acid, and shake for an additional 10 minutes. Dilute with water to volume, and mix. Pass through a 0.45-µm membrane filter, discarding the first 5 mL of the filtrate. Use the subsequent filtrate as the Assay preparation.
Chromatographic system
(see Chromatography
![]() ![]()
Procedure
Separately inject equal volumes (about 20 µL) of the Assay preparation and the Standard preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of protriptyline hydrochloride (C19H21N·HCl) in the portion of Tablets taken by the formula:
200C(rU / rS)
in which C is the concentration, in mg per mL, of USP Protriptyline Hydrochloride RS in the Standard preparation; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
Chromatographic Column
USP32NF27 Page 3437
Chromatographic columns text is not derived from, and not part of, USP 32 or NF 27.
|