Triprolidine Hydrochloride Oral Solution
» Triprolidine Hydrochloride Oral Solution contains not less than 90.0 percent and not more than 110.0 percent of the labeled amount of triprolidine hydrochloride (C19H22N2·HCl·H2O).
Packaging and storage
Preserve in tight, light-resistant containers.
Identification
A:
Transfer a volume of Oral Solution, equivalent to about 12 mg of triprolidine hydrochloride, to a 125-mL separator, add 25 mL of water, then add 4 mL of sodium hydroxide solution (1 in 2), and mix. Add 10 mL of cyclohexane, shake, allow the phases to separate completely, and discard the aqueous layer. Transfer 8 mL of the cyclohexane solution to a glass-stoppered, 25-mL conical flask, evaporate on a steam bath with the aid of a current of air to dryness, and continue to heat the flask for about 1 minute after the solvent has completely evaporated. Cool, add 2 mL of cyclohexane, and mix: the IR absorption spectrum of the cyclohexane solution so obtained exhibits maxima only at the same wavelengths as that of a similar preparation of USP Triprolidine Hydrochloride RS.
B:
The retention time of the major peak in the chromatogram of the Assay preparation corresponds to that in the chromatogram of the Standard preparation, as obtained in the Assay.
pH 791:
between 5.6 and 6.6.
Alcohol content, Method II 611:
between 3.0% and 5.0% of C2H5OH.
Assay
Mobile phase
Prepare a suitable degassed and filtered mixture of alcohol and ammonium acetate solution (1 in 250) (17:3).
Standard preparation
Dissolve an accurately weighed quantity of USP Triprolidine Hydrochloride RS in 0.01 N hydrochloric acid, and dilute quantitatively and stepwise with 0.01 N hydrochloric acid to obtain a solution having a known concentration of about 0.05 mg of anhydrous USP Triprolidine Hydrochloride RS per mL.
Assay preparation
Transfer an accurately measured volume of Oral Solution, equivalent to about 2.5 mg of triprolidine hydrochloride, to a 50-mL volumetric flask, dilute with 0.01 N hydrochloric acid to volume, and mix.
Chromatographic system (see Chromatography 621)
The liquid chromatograph is equipped with a 254-nm detector and a 4.2-mm × 25-cm column that contains packing L3. The flow rate is about 1.5 mL per minute. Chromatograph five replicate injections of the Standard preparation, and record the peak responses as directed for Procedure: the relative standard deviation is not more than 2.0%; and the tailing factor is not more than 1.5.
Procedure
Separately inject equal volumes (about 10 µL) of the Standard preparation and the Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. Calculate the quantity, in mg, of triprolidine hydrochloride (C19H22N2·HCl·H2O) in the portion of Oral Solution taken by the formula:
(332.88/314.86)(50C)(rU / rS)
in which 332.88 and 314.86 are the molecular weights of triprolidine hydrochloride monohydrate and anhydrous triprolidine hydrochloride, respectively; C is the concentration, in mg per mL, calculated on the anhydrous basis, of USP Triprolidine Hydrochloride RS in the Standard preparation; and rU and rS are the peak responses obtained from the Assay preparation and the Standard preparation, respectively.
Auxiliary Information
Please check for your question in the FAQs before contacting USP.
USP35NF30 Page 4960
Pharmacopeial Forum: Volume No. 28(2) Page 391
|